DOD American Metal

Another quick one. This American Metal would power up, pass a clean signal but wouldn't pass an effected signal.

Schematics are older DOD pedals aren't too hard to come by (I believe some of them were supplied in the original boxes). I suspected a bad switching JFET was blocking signal, but they all measured fine on the oscilloscope.

I found that two of the transistors near the distortion control had very little voltage on the collectors. The schematic shows a series 1k resistor and a 47uF capacitor from the 9V supply, so there's a good chance that capacitor is shorted.

The 47uF is right in the middle of the PCB. Pulling out brought back the effected signal, so I replaced it and put things back together.

This is a very cool pedal, definitely in the HM-2 family. Maybe not as much gain and not as much EQ control, but it certainly does the buzzsaw sound when turned up.