Digitech PDS 1700 Chorus/Flanger

I picked this up out of curiosity, I'm fond of the PDS series and the off-the-shelf design. This is a digital Chorus and Flanger, where the traditional BBD design has been replaced with an 8-bit digital delay line (i.e. not DSP or modelling) and the delayed signal mixed in the analog domain. This one worked but didn't switch very well.

PDS 1700

There aren't too many surprises when comparing the insides to the PDS delays. There is the same ADC (ADC0820) but instead of DRAM it uses a single 2k 6116 SRAM. This is probably because the required delay times for a Chorus and Flanger are much shorter (this pedal maxes out at 51 ms) they could spring for the more expensive SRAM. This also means all the DRAM refresh circuitry isn't needed, and there are fewer logic chips overall.

Guts

PCB Backside

The switches were pretty flaky. The mechanical design DOD/Digitech used at the time has a poor reputation for reliability. I find that if they are maintained they work well, but I don't think they stand up to force. The classic problem is that switches that won't switch on the first try get a harder stomp the second time, and things deteriorate.

PDS hardware. Input jack looks non-original.

The paddles press down on momentary push buttons on PCBs inside the pedal. The paddles bear against two bolts that pass through slightly oversized holes in the enclosure. There is a preloaded spring on the bolts on the insides to push them against the enclosure, with nuts holding the springs under tension. There is another return spring on the switch PCB to bounce the paddle back.

I replaced the switches, I'm using these. There was some play in the paddles, the bypass one would rotate slightly in place, meaning it would not always hit the button switch. I tightened down the nuts on the inside until this play was removed, then it switched every time. You need a 3/32" hex key and a 1/4" socket wrench to make the adjustment.

The effects are cool. There is interesting play between the delay time and depth controls, the flanger side can go from covering high to lower-frequency ranges, kind of like the difference between a Boss BF-2 and a HF-2. The chorus does odd (cool) detuning effects at high delay times, modulated chorus in the middle and traditional chorus at minimum delay.

I have this one listed on Reverb if anyone is interested.